Allied Telesis AT-S63 - Manual (Page 584)

Chapter 31: Port-based VLAN, Tagged VLAN, and Multiple VLAN Mode Commands
584 Section VI: Virtual LANs
ADD VLAN
Syntax 1
add vlan= name [vid= vid ] ports= ports |all
frame=untagged|tagged
Syntax 2
add vlan= name [vid= vid ] taggedports= ports |all
untaggedports= ports |all
Parameters
vlan Specifies the name of the VLAN to modify.
vid Specifies the VID of the VLAN you want to modify. This
parameter is optional.
ports Specifies the ports to be added to the VLAN. You can
add more than one port at a time. For instructions on
how to enter port numbers, refer to “Port Numbers in
Commands” on page 47.
frame Identifies the new ports as either tagged or untagged.
This parameter must be used with the PORT
parameter.
taggedports Specifies the ports to be added as tagged ports to the
VLAN. To include all ports on the switch as tagged
ports in the VLAN, use ALL.
untaggedports Specifies the ports to be added as untagged ports to
the VLAN. Specifying ALL adds all ports on the switch
as untagged ports to the VLAN.
Description
This command adds tagged and untagged ports to an existing port-based
or tagged VLAN.
Note
To initially create a VLAN, see “CREATE VLAN” on page 587. To
remove ports from a VLAN, see “DELETE VLAN” on page 591.
Command
Available
AlliedWare Plus