Allied Telesis AT-S63 - Manual (Page 730)

Chapter 39: 802.1x Port-based Network Access Control Commands
730 Section VIII: Port Security
ENABLE PORTACCESS|PORTAUTH
Syntax
enable portaccess|portauth
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
None.
Description
This command activates 802.1x Port-based Network Access Control on
the switch. The default setting for this feature is disabled.
Note
You should activate and configure the RADIUS client software on
the switch before activating port-based access control. Refer to
“SET AUTHENTICATION” on page 812.
Example
The following command activates 802.1x Port-based Network Access
Control on the switch:
enable portaccess
AlliedWare Plus
Command
Syntax
dot1x system-auth-ctrl
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# dot1x system-auth-ctrl
Command
Available
AlliedWare Plus