Enable telnet, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 66
Advertising
Chapter 3: Basic Switch Commands
66
Section I: Basic Operations
ENABLE TELNET
Syntax
enable telnet
Parameters
None.
Description
This command activates the Telnet server on the switch. When the server
is active, you can use a Telnet client to remotely manage the switch. To
disable the server, refer to “DISABLE TELNET” on page 65. The default
setting for the Telnet server is enabled.
Example
The following command activates the Telnet server:
enable telnet
AlliedWare Plus
Command
Syntax
service telnet
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# service telnet
Command
Available
AlliedWare Plus
Advertising