Allied Telesis AT-S63 - Manual (Page 190)

Chapter 10: MAC Address Table Commands
190 Section I: Basic Operations
SET SWITCH AGINGTIMER|AGEINGTIMER
Syntax
set switch agingtimer|ageingtimer= value
Parameter
agingtimer or Specifies the aging timer for the MAC address table.
ageingtimer The value is in seconds. The range is 0 to 1048575.
The default is 300 seconds (5 minutes). The
parameters are equivalent.
Description
This command is used to set the aging timer, which the switch uses to
delete inactive dynamic MAC addresses from the MAC address table. This
prevents the table from becoming full of addresses of inactive nodes.
Addresses are considered inactive if no packets are sent to or received
from the nodes of the addresses for the duration of the timer.
Setting the aging timer to 0 disables the timer. No dynamic MAC
addresses are aged out and the table stops learning new addresses after
reaching its maximum capacity.
To view the current setting for the MAC address aging timer, refer to
“SHOW SWITCH AGINGTIMER|AGEINGTIMER” on page 192.
Example
The following command sets the aging timer to 120 seconds (2 minutes):
set switch agingtimer=120
AlliedWare Plus
Command
Syntax
mac address-table ageing-time value
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Command
Available
AlliedWare Plus