Allied Telesis AT-S63 - Manual (Page 441)

AT-S63 Management Software Command Line User’s Guide
Section III: Snooping Protocols 441
static MAC addresses. The range is 1 to 255
addresses; the default is 64 addresses.
Note
The combined number of multicast address groups for IGMP and
MLD snooping cannot exceed 255.
routerport Specifies the port(s) on the switch
connected to a multicast router. Options are:
port Specifies the router port(s)
manually.
all Specifies all of the switch ports.
none Sets the mode to manual
without any router ports
specified.
auto Activates auto-detect, where
the switch automatically
determines the ports with
multicast routers.
Description
This command configures the MLD snooping parameters.
Examples
The following command activates MLD snooping, sets the MLD topology
to Multi-Host, and sets the timeout value to 120 seconds:
set ipv6 mldsnooping snoopingstatus=enabled
hoststatus=multihost timeout=120
The following command changes the topology to Single-Host:
set ipv6 mldsnooping hoststatus=singlehost
The following command disables MLD snooping:
set ipv6 mldsnooping snoopingstatus=disabled
Equivalent Commands
disable mldsnooping
For information, see “DISABLE MLDSNOOPING” on page 438.
enable mldsnooping
For information, see “ENABLE MLDSNOOPING” on page 439.