Allied Telesis AT-S63 - Manual (Page 186)

Chapter 10: MAC Address Table Commands
186 Section I: Basic Operations
DELETE SWITCH FDB|FILTER
Syntax 1
delete switch fdb|filter
macaddress|destaddress=
macaddress vlan= name | vid
Syntax 2
delete switch fdb|filter
type|status=static|staticunicast|staticmulticast|dynamic|
dynamicunicast|dynamicmulticast
Note
The FDB and FILTER keywords are equivalent.
Parameters
macaddress or Deletes a dynamic or static unicast or multicast MAC
destaddress
address from the MAC address table. The address can
be entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
This parameter must be accompanied with the VLAN
parameter.
vlan Specifies the VLAN containing the port(s) where the
address was learned or assigned. The VLAN can be
specified by name or VID. This parameter must be used
with the MACADDRESS and DESTADDRESS
parameters.
type or Deletes specific types of MAC addresses. Options are:
status
static Deletes all static unicast and
multicast MAC addresses.
staticunicast Deletes all static unicast addresses.
staticmulticast Deletes all static multicast
addresses.
dynamic Deletes all dynamic unicast and
multicast MAC addresses.
dynamicunicast Deletes all dynamic unicast
addresses.
Command
Available
AlliedWare Plus