Allied Telesis AT-S63 - Manual (Page 97)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 97
ˆ Application: The version number and build date of the AT-S63
Management Software.
ˆ System Name: The name of the switch.
ˆ Administrator: The name of the network administrator responsible for
managing the switch.
ˆ Location: The location of the switch, (for example, 4th Floor - rm
402B).
Note
To configure the name, administrator, and location parameters, refer
to “SET SYSTEM” on page 82.
ˆ Power Information: The status of the main power supply, the
redundant power supply (if present), and internal power consumption.
ˆ Temperature (Deg.C): The ambient temperature as measured where
the air enters the cooling vents on the side of the unit.
ˆ Fan Information: The speed or operating status of the system fan(s).
If you are managing a Basic Layer 3 stack, you can use the VERSION and
MODULE parameters of this command to display the version numbers of
the AT-S63 Management Software on the switches.
Examples
The following command displays the above information about the switch:
show system
The following command displays the version numbers of the management
software on all of the switches in a stack:
show system version module=all
AlliedWare Plus
Command
Syntax
show system
Modes
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus# show system