Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 74
Chapter 3: Basic Switch Commands
74
Section I: Basic Operations
management session. Otherwise, the switch reverts to the previous
configuration the next time you reset the switch.
Note
The switch does not forward network traffic during the reset process.
Some network traffic may be lost.
For the list of the default values, refer to the AT-S63 Management
Software Features Guide.
Your local or remote management session with the switch ends when you
reset the switch. You must reestablish the session to continue managing
the switch.
Examples
The following command configures the switch using the configuration file
named
switch12.cfg
:
restart switch config=switch12.cfg
The following command resets the switch to its default values:
restart switch config=none
The following command resets the switch:
restart switch
Equivalent Command
restart reboot
For information, see “RESTART REBOOT” on page 71.
AlliedWare Plus
Command
Syntax
system factory-reset
erase startup-config
Mode
Privileged Exec mode
Description
You can use either of these commands to restore the default settings on
the switch. However, you cannot use the commands to reset the switch or
to load a different configuration file.