Allied Telesis AT-S63 - Manual (Page 154)

Chapter 8: Port Parameter Commands
154 Section I: Basic Operations
PURGE SWITCH PORT
Syntax
purge switch port= port
Parameters
port Specifies the port whose parameter settings are to be
returned to the default values. You can configure more
than one port at a time.
Description
This command returns all of the parameter settings of a port to the factory
default values. To reset a port and retain its settings, use “RESET
SWITCH PORT” on page 155.
Example
The following example resets the settings for port 10 to the factory default
values:
purge switch port=10