Allied Telesis AT-S63 - Manual (Page 563)

AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols 563
Description
This command configures the following MSTP parameter settings.
ˆ Hello time
ˆ Forwarding delay
ˆ Maximum age time
ˆ Maximum hop count
ˆ Force version of STP or normal MSTP
ˆ Configuration name
ˆ Revision level
Examples
The following command disables MSTP and returns all MSTP parameter
settings to their default values:
set mstp default
The following command sets the hop count to 10, the configuration name
to Engineering Region, and the reversion level to 2:
set mstp maxhops=10 configname="Engineering Region"
revisionlevel=2
The following command uses the FORCEVERSION parameter to
configure the bridge to use the MSTP parameters but to transmit only STP
BPDU packets:
set mstp forceversion=forcestpcompatible
Equivalent Command
purge mstp
For information, see “PURGE MSTP” on page 560. This command
performs the same function as the DEFAULT parameter.
AlliedWare Plus
Command
Syntax
revision revisionlevel
region configname
Mode
Multiple spanning tree mode