Allied Telesis AT-S63 - Manual (Page 242)

Chapter 14: File System Commands
242 Section II: Advanced Operations
RENAME
Syntax
rename [cflash:] filename1.ext [cflash:] filename2.ext
Parameters
filename1.ext Specifies the name of the file to be renamed.
If the name contains spaces, enclose it in
double quotes. Otherwise, the quotes are
optional. If the file is stored on a compact
memory card, precede the name with
“cflash:”.
filename2.ext Specifies the new name for the file. The
filename can be from 1 to 16 alphanumeric
characters, not including the filename
extension. Spaces are allowed. If the name
contains spaces, it must be enclosed in
double quotes. The filename extension must
be the same as in the original filename. The
new name must be unique in the file system.
If the file is stored on a compact memory card,
precede the name with “cflash:”.
Description
This command renames a file in a switch’s file system or on a compact
flash memory card. The source and destination file extensions must be the
same.
Note the following before using this command:
ˆ Files with the extension UKF are encryption key pairs. These files
cannot be copied, renamed, or deleted from the file system.
ˆ Renaming the active boot configuration file and then resetting the
switch returns the unit to its default parameter settings, unless you
save the current configuration or select another active boot
configuration file. For instructions on how to change the active boot
configuration file, see “SET CONFIG” on page 245.
ˆ The command does not accept a directory path. To rename a file on a
compact flash card, you must first change to the directory where the
file is stored. For instructions, refer to “SET CFLASH DIR” on
page 244.
ˆ The source and destination locations must be the same.
Command
Available
AlliedWare Plus