Allied Telesis AT-S63 - Manual (Page 544)

Chapter 29: Rapid Spanning Tree Protocol (RSTP) Commands
544 Section V: Spanning Tree Protocols
no, off, false The port is not an point-to-point port.
The parameters are equivalent. are
equivalent.
autoupdate The port’s status is determined
automatically. This is the default.
migrationcheck Enables and disables migration check. The purpose of
this feature is to change from the RSTP mode to the
STP mode if STP BDPU packets are received on the
selected port. When you enable this option, the bridge
will send out RSTP BPDU packets from the selected
port until STP BPDU packets are received. The port will
remain in the RSTP mode until it receives an STP
BPDU packet. The options are:
yes, on, true Enable migration check. The options
are equivalent.
no, off, false Disable migration check. The options
are equivalent.
Description
This command sets a port’s RSTP settings.
Examples
The following command sets the port cost to 1,000,000 and port priority to
224 (increment 14) on port 4:
set rstp port=4 portcost=1000000 portpriority=14
The following command changes ports 6 to 8 so they are not considered
edge ports:
set rstp port=6-8 edgeport=no
AlliedWare Plus
Command
Syntax
spanning-tree path-cost path-cost
spanning-tree priority priority
spanning-tree edgeport|portfast
spanning-tree link-type point-to-point|shared
Note
The EDGEPORT and PORTFAST parameters are equivalent.
Mode
Port Interface mode