Command mode prompts, Moving down the hierarchy, Command mode prompts moving down the hierarchy – Allied Telesis AT-S63 User Manual
Page 40: Awplus command
Chapter 1: Overview
40
Section I: Basic Operations
Command Mode
Prompts
It’s easy to know where you are in the hierarchy because nearly all the
modes have different prompts. (The only two modes that have the same
prompt are the Port Interface mode and the VLAN Interface mode.)
Figure 7. Command Mode Prompts
Moving Down the
Hierarchy
To move down through the hierarchy, you have to move through the
modes in sequence. Skipping modes is not allowed.
There is a different command for each mode. To move from the User Exec
mode to the Privileged Exec mode, for instance, use the ENABLE
command. Some of the commands require a value, like the INTERFACE
PORT command which must have one or more port numbers and which is
used to enter the Port Interface mode.
AWPLUS Command
You enter this command at the standard command line prompt to enter the
AlliedWare Plus command line interface and the User Exec mode. If you
log on as an operator, this is as far in the hierarchy as you can go. To go
further, you have to log on as a manager.
Privileged
Executive
Mode
User
Executive
Mode
Configure
Terminal
Mode
Multiple
Tree Mode
Spanning
Class-Map
Mode
VLAN
Mode
Interface
Port
Mode
Interface
Line
Mode
Console
Policy Map
Mode
Class
Mode
(config-vlan)#
(config-pmap)#
(config-pmap-c)#
(config-line)#
(config-if)#
(config-if)#
(config-cmap)#
(config-mst)#
awplus(config)#
awplus#
awplus>
VLAN
Mode
Configuration