Allied Telesis AT-S63 - Manual (Page 564)

Chapter 30: Multiple Spanning Tree Protocol (MSTP) Commands
564 Section V: Spanning Tree Protocols
Description
The only MSTP parameters you can change with these AlliedWare Plus
commands compared with the standard command are the MSTP region
name and revision level. To change the other parameters, use the
standard command or another management interface.
Example
This example sets the region’s revision level to 10 and its name to
‘sw10a:’
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mst configuration
awplus(config-mst)# revision 10
awplus(config-mst)# region sw10a