Allied Telesis AT-S63 - Manual (Page 732)

Chapter 39: 802.1x Port-based Network Access Control Commands
732 Section VIII: Port Security
SET PORTACCESS|PORTAUTH PORT ROLE=AUTHENTICATOR
Syntax
set portaccess|portauth=8021x|macbased port= port
type|role=authenticator|none [mode=single|multi]
[control=auto|authorised|forceauthenticate|
unauthorised|forceunauthenticate]
[quietperiod=
value ] [txperiod= value ]
[reauthenabled=enabled|disabled] [reauthperiod= value ]
[supptimeout= value ] [servertimeout|servtimeout= value ]
[maxreq= value ] [ctrldirboth=ingress|both]
[piggyback=enabled|disabled] [guestvlan= vlan-name | vid |none]
[vlanassignment=enabled|disabled] [securevlan=on|off]
Parameters
portaccess or Specifies the authentication method. The two choices
portauth are:
8021x Specifies 802.1x username
and password authentication.
With this authentication
method a supplicant must
provide, either manually or
automatically, a username and
password. This authentication
method requires 802.1x client
software on the supplicant
nodes.
macbased Specifies MAC address-based
authentication. The
authenticator port extracts the
source MAC address from the
initial frames received from a
supplicant and automatically
sends the address as both the
username and password of the
supplicant to the authentication
server. This authentication
method does not require
802.1x client software on the
supplicant nodes.
port Specifies the port to set to the Authenticator role or
whose Authenticator settings you want to adjust. You
can specify more than one port at a time.
Command
Available
AlliedWare Plus