Allied Telesis AT-S63 - Manual (Page 575)

AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols 575
SHOW MSTP
Syntax
show mstp [portconfig= ports ] [portstate= ports ]
[stpid= msti_id ] [mstistate] [cist] [mstivlanassoc]
Parameters
portconfig Displays the MSTP settings of a port. You can specify
more than one port at a time. For a list of the MSTP
information displayed by this parameter, refer to the
Description below.
portstate Displays the MSTP state of a port. You can specify
more than one port at a time. For a list of the MSTP
information displayed by this parameter, refer to
Description below.
stpid Specifies an MSTI ID. This parameter is used with the
PORTCONFIG and PORTSTATE parameters to view
the MSTP settings of ports that belong to VLANs that
are members of different MSTIs. You can specify more
than one MSTI ID.
mstistate Displays a list of the MSTIs on the switch and their
associated VLANs. The list does not include the CIST.
cist Displays the CIST priority and the VLANs associated
with CIST.
mstivlanassoc Displays a list of the MSTIs on the switch, including the
CIST, and their associated VLANs.
Note
You can specify only one parameter at a time in this command. The
only exception is the STPID parameter, which is used with the
PORTCONFIG and PORTSTATE parameters.
Description
This command displays MSTP parameters. Entering SHOW MSTP
without any parameters displays the following MSTP settings:
ˆ MSTP status
ˆ Force version
ˆ Hello time
Command
Available
AlliedWare Plus