Allied Telesis AT-S63 - Manual (Page 44)

Chapter 1: Overview
44 Section I: Basic Operations
VLAN DATABASE Command
You use this command to move from the Configuration Terminal mode to
the VLAN Configuration mode which you use to create VLANs.
Figure 19. Moving from the Configure Terminal Mode to the VLAN
DATABASE Mode with the LINE CONSOLE Command
INTERFACE VLAN Command
You use this command to move from the Configure Terminal mode to the
VLAN Interface mode to create routing interfaces and to designate the
local interface. You can specify only one VLAN and the VLAN must be
indicated by its name and not by its VID. This example enters the VLAN
Interface mode for the Sales VLAN.
Figure 20. Moving from the Configure Terminal Mode to the VLAN
Interface Mode with the INTERFACE VLAN Command
This example enters the VLAN Interface mode for the Default_VLAN.
Figure 21. Moving from the Configure Terminal Mode to the VLAN
Interface Mode with the INTERFACE VLAN Command
awplus(config)# vlan database
awplus(config-vlan)#
awplus(config)# interface Sales
awplus(config-if)#
awplus(config)# interface default_vlan
awplus(config-if)#