Allied Telesis AT-S63 - Manual (Page 558)

Chapter 30: Multiple Spanning Tree Protocol (MSTP) Commands
558 Section V: Spanning Tree Protocols
DISABLE MSTP
Syntax
disable mstp
Parameters
None.
Description
This command disables the Multiple Spanning Tree Protocol on the
switch. To view the current status of MSTP, refer to “SHOW MSTP” on
page 575.
Example
The following command disables MSTP:
disable mstp
AlliedWare Plus
Command
Syntax
no spanning-tree mstp enable bridge-forward
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# no spanning-tree mstp enable bridge-forward
Command
Available
AlliedWare Plus