Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 666
Chapter 35: Internet Protocol Version 4 Packet Routing Commands
666
Section VII: Internet Protocol Routing
AlliedWare Plus
Command
Syntax
interface
vlan_name
ifconfig eth0
Mode
VLAN Interface mode
Description
This command has the following rules and restrictions:
The VLAN must be identified by its name and not by its VID.
This command does not allow you to specify a routing interface
number and assumes ID number 0. Thus, you cannot use this
command to designate as the local interface a routing interface with a
number other than 0. For example, you could use this command to
make VLAN4-0 the local interface, but not VLAN4-1.
Example
This example designates interface 0 in the Support VLAN as the local
interface:
awplus> enable
awplus# configure terminal
awplus(config)# interface Support
awplus(config-if)# ifconfig eth0