Allied Telesis AT-S63 - Manual (Page 646)

Chapter 35: Internet Protocol Version 4 Packet Routing Commands
646 Section VII: Internet Protocol Routing
Passwords are sent in plaintext. The AT-S63
Management Software does not support encrypted
passwords.
Passwords are not supported in RIP version 1.
poisonreverse Specifies the status for split horizon and split horizon
with poison reverse. The options are:
yes, on, true Split horizon with poison reverse is
enabled. These values are
equivalent.
no, off, false Split horizon with poison reverse is
disabled, and split horizon is
executed. This is the default setting.
These values are equivalent.
autosummary Specifies the status of autosummary of routes. The
options are:
yes, on, true Activates autosummarization of
routes. These values are equivalent.
no, off, false Disables autosummarization. This is
the default setting. These values are
equivalent.
Description
This command adds RIP to an interface. It also controls the type of RIP
packets sent to and accepted by the interface.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command adds RIP to the VLAN5-0 interface and configures the
routing protocol to send and accept only version 1 packets. No password
is specified since RIP version 1 does not support passwords.
add ip rip interface=vlan5-0 send=rip1 receive=rip1
This command adds RIP to the VLAN10-0 interface and configures the
routing protocol to send version 2 packets and accept packets of either
version. Password protection is not used:
add ip rip interface=vlan10-0 send=rip2 receive=both
authentication=none