Allied Telesis AT-S63 - Manual (Page 759)

AT-S63 Management Software Command Line User’s Guide
Section IX: Management Security 759
SET HTTP SERVER
Syntax
set http server [security=enabled|disabled] [sslkeyid= key-
id ] [port= port ]
Parameters
security Specifies the security mode of the web server. The
options are:
enabled Specifies that the web server is to
function in the secure HTTPS mode.
disabled Specifies that the web server is to
function in the non-secure HTTP
mode. This is the default.
sslkeyid Specifies a key pair ID. This parameter is required if
you are configuring the web server to operate in the
secure HTTPS mode.
port Specifies the TCP port number that the web server
will listen on. The defaults are port 80 for non-secure
HTTP operation and port 443 for secure HTTPS
operation.
Description
This command configures the web server. You can configure the server for
either secure HTTPS or non-secure HTTP operation.
Before configuring the web server, please note the following:
ˆ You cannot use this command when the web server is enabled. You
must first disable the web server before making changes. To disable
the server, refer to “DISABLE HTTP SERVER” on page 756.
ˆ To configure the web server for the HTTPS secure mode, you must
first create an encryption key and a certificate, and add the certificate
to the certificate database. The management software will not allow
you to configure the web server for the secure HTTPS mode until
those steps have been completed.