Allied Telesis AT-S63 - Manual (Page 530)

Chapter 28: Spanning Tree Protocol (STP) Commands
530 Section V: Spanning Tree Protocols
SHOW STP
Syntax
show stp [port= port ]
Parameter
port Specifies the port whose STP parameters you want to
view. You can view more than one port at a time.For
instructions, refer to “Port Numbers in Commands” on
page 47
Description
This command displays the current values for the STP parameters. An
example of the display is shown in Figure 65.
Figure 65. SHOW STP Command
The bridge priority, bridge hello time, and bridge max age parameters
display two values when STP is enabled on the switch (for example,
Bridge Forwarding Delay .. 15/15). The first number is the configured
value on the switch for the parameter and the second is the value the
switch obtained from the root bridge and is actually using for the
parameter. The switch displays only the configured values when spanning
tree is not activated on the switch.
The Status parameter displays whether STP is enabled or disabled on the
switch.
For definitions of the bridge priority, hello time, forwarding delay, and max
age parameters, refer to “SET STP” on page 522.
The bridge Identifier parameter consists of the switch’s bridge priority
value and MAC address, separated by a slash (/). To change the switch’s
priority value, refer to “SET STP” on page 522. The MAC address of the
switch cannot be changed.the MAC address of the switch.
Command
Available
AlliedWare Plus
Status ...................... Enabled
Bridge Priority ............. 32768 (In multiples of 4096: 8)
Bridge Hello Time ........... 2/2 (Configured/Actual)
Bridge Forwarding Delay ..... 15/15 (Configured/Actual)
Bridge Max Age .............. 20/20 (Configured/Actual)
Bridge Identifier ........... 32768/00:21:46:A7:B4:11
Root Bridge ................. 32768/00:21:46:A7:B4:11
Root Path Cost .............. 0