Allied Telesis AT-S63 - Manual (Page 688)

Chapter 36: BOOTP Relay Commands
688 Section VII: Internet Protocol Routing
ADD BOOTP RELAY
Syntax
add bootp relay= ipaddress
Parameters
ipaddress Specifies the IP address of a DHCP or BOOTP
server.
Description
This command specifies the IP address of a DHCP or BOOTP server. The
switch can store up to eight server IP addresses, but you can specify only
one at a time with this command.
Example
This example adds the IP address 145.42.19.162 as a DHCP or BOOTP
server:
add bootp relay=145.42.19.162