Disable switch port flow, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 149
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
149
DISABLE SWITCH PORT FLOW
Syntax
disable switch port=
port
flow=pause
Parameter
port
Specifies the port where you want to deactivate flow
control. You can configure more than one port at a time.
Description
This command deactivates flow control on a port. Flow control only applies
to ports operating in full duplex mode.
Example
The following command deactivates flow control on port 6:
disable switch port=6 flow=pause
Equivalent Command
set switch port=
port
flowcontrol=disable
For information, see “SET SWITCH PORT” on page 156.
AlliedWare Plus
Command
Syntax
flowcontrol receive|send off
Mode
Port Interface mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
This example disables flow control on ports 18 to 21 and 24:
awplus> enable
awplus# configure terminal
awplus(config)# interface 18-21,24
awplus(config-if)# flowcontrol receive off
Command
Available
AlliedWare Plus