Allied Telesis AT-S63 - Manual (Page 312)

Chapter 17: Classifier Commands
312 Section II: Advanced Operations
tcpsport Defines a traffic flow by a source TCP port.
tcpdport Defines a traffic flow by a destination TCP port.
udpsport Defines a traffic flow by a source UDP port.
udpdport Defines a traffic flow by a destination UDP port.
tcpflags Defines a traffic flow by a TCP flag. Options are
URG - Urgent
ACK - Acknowledgement
RST - Reset
PSH - Push
SYN - Synchronization
FIN - Finish
Description
This command is used to create classifiers. Classifiers define traffic flows
for access control lists (ACL) and Quality of Service policies. A traffic flow
consists of packets that share one or more characteristics. Traffic flows
can range from being very broad to very specific. An example of the
former might be all IP traffic while an example of the latter could be
packets with specific source and destination MAC addresses.
A classifier without any defined parameters applies to all packets.
The ANY option of the parameters is used to delete the current setting of a
parameter without setting a new value.
Examples
This command creates a classifier for all IP traffic:
create classifier=4 description=”IP flow” protocol=ip
This command creates a classifier for all traffic originating from the subnet
149.22.22.0 destined to the device with the IP address 149.44.44.11:
create classifier=4 description=”subnet flow”
ipsaddr=149.22.22.0/24 ipdaddr=149.44.44.11
This command creates a classifier for all HTTPS web traffic with a
destination IP address of 149.44.44.44:
create classifier=7 description=”HTTPS flow”
ipdaddr=149.44.44.44 tcpdport=443