Allied Telesis AT-S63 - Manual (Page 41)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 41
Figure 8. Using the AWPLUS Command to Start the AlliedWare Plus
Command Line Interface
ENABLE Command
You use this command to move from the User Exec mode to the Privileged
Exec mode.
Figure 9. Moving from the User Exec Mode to the Privileged Exec Mode
with the ENABLE Command
CONFIGURE TERMINAL Command
You use this command to move from the Privileged Exec mode to the
Configure Terminal mode.
Figure 10. Moving from the Privileged Exec Mode to the Configuration
Terminal Mode with the ENABLE Command
CLASS-MAP Command
You use this command to move from the Configure Terminal mode to the
Class-Map mode to create classifiers and flow groups for Quality of
Service policies.
Allied Telesis (TM) AT-9448Ts/XP AT-S63
Switch 12a
# awplus
AlliedWare Plus (TM) AT-9448Ts/XP AT-S63
awplus>
AlliedWare Plus (TM) AT-9448Ts/XP AT-S63
awplus> enable
awplus#
AlliedWare Plus (TM) AT-9448Ts/XP AT-S63
awplus> enable
awplus# configure terminal
awplus(config)#