Allied Telesis AT-S63 - Manual (Page 653)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 653
DELETE IP INTERFACE
Syntax
delete ip interface= interface
Parameters
interface Specifies the name of the interface to be deleted from
the switch. An interface name consists of “VLAN”
followed by the name or ID (VID) of the VLAN and the
interface number (e.g., vlan-Sales-0 or vlan4-0).
Description
This command is used to delete routing interfaces. You can only delete
one interface at a time. To display the names of the interfaces, refer to
“SHOW IP INTERFACE” on page 676.
Note the following before performing this command:
ˆ All IPv4 packet routing to the local network or subnet of a deleted
interface ceases.
ˆ All static routes assigned to the interface are deleted from the route
table.
ˆ Deleting an interface used by the AT-S63 Management Software to
access a network management device (e.g., a RADIUS or syslog
server) causes the switch to stop performing the management
function.
ˆ Deleting the local interface on a master switch of an enhanced stack
disables the device’s ability to function as the master switch.
ˆ Deleting the local interface of a switch during a remote Telnet or SSH
management session immediately ends the session if you accessed
the switch directly (i.e., not through enhanced stacking). To continue
managing the switch, you must start a local management session
using the Terminal Port on the unit.
Examples
This command deletes the VLAN6-2 interface from the switch:
delete ip interface=vlan6-2
This command deletes an interface using the name of the VLAN, in this
case Sales, instead of the VID:
delete ip interface=vlan-Sales-2
Command
Available
AlliedWare Plus