Show asyn – Allied Telesis AT-S63 User Manual
Page 88
Chapter 3: Basic Switch Commands
88
Section I: Basic Operations
SHOW ASYN
Syntax
show asyn
Parameters
None.
Description
This command displays the settings for the serial terminal port on the
switch, used for local management of the device. An example of the
display is shown in Figure 26.
Figure 26. SHOW ASYN Command
To configure the serial port’s baud rate, refer to “SET ASYN” on page 76.
To configure the command line prompt, refer to “SET PROMPT” on
page 59. You cannot adjust the parity, data bits, or stop bit of the serial
terminal port.
Example
The following command displays the serial terminal port settings:
show asyn
Asynchronous Port (Console) Information:
Baud Rate ................................. 115200
Parity .................................... NONE
Data bits ................................. 8
Stop bits ................................. 1
Prompt .................................... "Sales Switch"