Allied Telesis AT-S63 - Manual (Page 444)

Chapter 24: Multicast Listener Discovery (MLD) Snooping Commands
444 Section III: Snooping Protocols
SHOW IPV6 MLDSNOOPING
Syntax
show ipv6 mldsnooping [hostlist] [routerlist]
Parameters
hostlist Displays a list of the multicast groups learned by
the switch, as well as the ports on the switch that
are connected to host nodes. This parameter
displays information only when there are active
host nodes.
routerlist Displays the ports on the switch where multicast
routers are detected. This parameter displays
information only when there are active multicast
routers.
Description
This command displays the following MLD parameters:
ˆ MLD snooping status
ˆ Multicast host topology
ˆ Host/router timeout interval
ˆ Maximum multicast groups
ˆ Multicast router port(s)
ˆ Host and router lists
For instructions on how to set the MLD parameters, refer to “SET IPV6
MLDSNOOPING” on page 440.
This command without optional parameters displays the information in
Figure 62.
Figure 62. SHOW IPV6 MLDSNOOPING Command
MLD Snooping Configuration:
MLD Snooping Status ................ Enabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum MLD Multicast Groups ....... 64
Router Port(s) ..................... Auto Detect