Enable rstp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 536
Advertising
Chapter 29: Rapid Spanning Tree Protocol (RSTP) Commands
536
Section V: Spanning Tree Protocols
ENABLE RSTP
Syntax
enable rstp
Parameters
None.
Description
This command enables the Rapid Spanning Tree Protocol. To view the
current status of RSTP, use “SHOW RSTP” on page 546. The default
setting for RSTP is disabled.
You cannot enable RSTP until you have activated it with the ACTIVATE
RSTP command.
Example
The following command enables RSTP:
enable rstp
AlliedWare Plus
Command
Syntax
spanning-tree rstp enable
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree rstp enable
Command
Available
AlliedWare Plus
Advertising