Allied Telesis AT-S63 - Manual (Page 212)

Chapter 12: LACP Port Trunking Commands
212 Section I: Basic Operations
CREATE LACP AGGREGATOR
Syntax
create lacp aggregator= name |adminkey=0x key port= port
[distribution=macsrc|macdest|macboth|ipsrc|ipdest|ipboth]
Parameters
aggregator Specifies a name for the new aggregator. The name
can be up to 20 alphanumeric characters. No spaces or
special characters are allowed. If no name is specified,
the default name is DEFAULT_AGG followed by a
number.
adminkey Specifies an adminkey number for the aggregator. This
is a hexadecimal number in the range of 0x1 to 0xffff. If
this parameter is omitted, the default adminkey of the
lowest numbered port in the aggregator is used.
port Specifies the ports of the aggregator.
distribution Specifies the load distribution method, which can be
one of the following:
macsrc Source MAC address.
macdest Destination MAC address.
macboth Source and destination MAC
addresses. This is the default.
ipsrc Source IP address.
ipdest Destination IP address.
ipboth Source and destination IP addresses.
If this parameter is omitted, the source and destination
MAC addresses load distributed method is selected by
default.
Description
This command creates an LACP aggregator. Note the following when
creating a new aggregator:
ˆ You can specify either a name or an adminkey but not both when
creating a new aggregator.
Command
Available
AlliedWare Plus