Activate stp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 518
Chapter 28: Spanning Tree Protocol (STP) Commands
518
Section V: Spanning Tree Protocols
ACTIVATE STP
Syntax
activate stp
Parameters
None.
Description
Use this command to designate STP as the active spanning tree. You
cannot enable STP or configure its parameters until you have designated
it as the active spanning tree with this command.
Only one spanning tree protocol, STP, RSTP, or MSTP, can be active on
a switch or a stack at a time.
Example
This command designates STP as the active spanning tree:
activate stp
AlliedWare Plus
Command
Syntax
spanning-tree mode stp
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode stp
Command
Available
AlliedWare Plus