Disable lacp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 217
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
217
DISABLE LACP
Syntax
disable lacp
Parameters
None.
Description
This command disables LACP on the switch. The default is disabled.
Caution
Do not disable LACP if there are defined aggregators without first
disconnecting all cables connected to the aggregate trunk ports.
Otherwise, a network loop may occur, resulting in a broadcast storm
and poor network performance.
Example
The following command disables LACP on the switch:
disable lacp
Equivalent Command
set lacp state=disable
For information, see “SET LACP STATE” on page 222.
AlliedWare Plus
Command
There is no separate AlliedWare Plus command for disabling LACP. LACP
is automatically disabled when you delete the last aggregator on the
switch with the NO CHANNEL-GROUP command, described in
AlliedWare Plus Command section in “DELETE LACP PORT” on
page 214.
Command
Available
AlliedWare Plus