Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 159
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
159
The following command sets the speed on ports 2 to 6 to 100 Mbps, the
duplex mode to full duplex, the wiring configuration to MDI-X, and flow
control to enabled:
set switch port=2-6 speed=100mfull mdimode=mdix
flowcontrol=enabled
The following command resets port 5:
set switch port=5 softreset
Equivalent Commands
disable switch port=
port
For information, see “DISABLE SWITCH PORT” on page 148.
disable switch port=
port
flow=pause
For information, see “DISABLE SWITCH PORT FLOW” on page 149.
enable switch port=
port
For information, see “ENABLE SWITCH PORT” on page 152.
enable switch port=
port
flow=pause
For information, see “ENABLE SWITCH PORT FLOW” on page 153.
reset switch port=
port
For information, see “RESET SWITCH PORT” on page 155.
AlliedWare Plus
Command
Syntax
To set a port’s speed:
speed auto|10mhalf|10mfull|100mhalf|100mfull|1000mfull]
To set a port’s MDI/MDIX setting:
mdix mdi|mdix
To set a port’s description:
description=
description
To disable a port:
shutdown
To enable a port:
no shutdown