Ping, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 67
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
67
PING
Syntax
ping
ipaddress
Parameter
ipaddress
Specifies the IP address of an end node to be pinged.
Description
This command instructs the switch to ping an end node. You can use this
command to determine whether an active link exists between the switch
and another network device.
Note
The switch can only ping a device if there is a routing interface on
the local subnet leading to the device. The switch uses the IP
address of the interface as its source address. For instructions on
how to add a routing interface to the switch, refer to “ADD IP
INTERFACE” on page 642.
Example
The following command pings an end node with the IP address of
149.245.22.22
ping 149.245.22.22
The results of the ping are displayed on the screen.
AlliedWare Plus
Command
Syntax
ping
ipaddress
Modes
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> ping 149.122.14.15
Command
Available
AlliedWare Plus