Reset system, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 69
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
69
RESET SYSTEM
Syntax
reset system [name] [contact] [location]
Parameters
name
Deletes the switch’s name.
contact
Deletes the switch’s contact.
location
Deletes the switch’s location.
Description
This command is used to delete the switch’s name, the name of the
network administrator responsible for managing the unit, and the location
of the unit. To set these parameters, refer to “SET SYSTEM” on page 82.
To view the current settings, refer to “SHOW SYSTEM” on page 96.
Examples
This command deletes all three parameter settings:
reset system
This command deletes just the name:
reset system name
AlliedWare Plus
Command
Syntax
no
hostname
Mode
Configure mode
Description
You use this command to delete the switch’s name. You cannot delete the
contact or the location from the AlliedWare Plus command interface.
Command
Available
AlliedWare Plus