Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 750
Chapter 39: 802.1x Port-based Network Access Control Commands
750
Section VIII: Port Security
This command displays the configuration settings and the status for port
10:
show portaccess port=10
This command displays the configuration settings and status for port 12
which is a MAC address-based authenticator port:
show portaccess=8021x=macbased port=12
This command displays just the status information for supplicant port 17:
show portaccess port=17 supplicant status
AlliedWare Plus
Command
Syntax
show dot1x statistics
Modes
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command displays a combination of the information
from the following standard commands:
show portauth port=all authenticator|supplicant config
show authentication
For information on these commands, refer to “SHOW
PORTACCESS|PORTAUTH PORT” on page 748 and “SHOW
AUTHENTICATION” on page 814.
Examples
awplus# show dot1x statistics