Purge snmpv3 notify – Allied Telesis AT-S63 User Manual
Page 487
Advertising
AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3
487
PURGE SNMPV3 NOTIFY
Syntax
purge snmpv3 notify
Parameters
None
Description
This command resets the SNMPv3 Notify Table to its default value by
removing all the notify table entries. To remove a single entry, use
“DESTROY SNMPv3 NOTIFY” on page 481.
Example
The following example removes all the entries from the SNMPv3 Notify
Table:
purge snmpv3 notify
Advertising