Disable stp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 519
Advertising
AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols
519
DISABLE STP
Syntax
disable stp
Parameters
None.
Description
This command disables the Spanning Tree Protocol. To view the current
status of STP, refer to “SHOW STP” on page 530. The default setting for
STP is disabled.
Example
The following command disables STP:
disable stp
AlliedWare Plus
Command
Syntax
no spanning-tree stp enable bridge-forward
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# no spanning-tree stp enable bridge-forward
Command
Available
AlliedWare Plus
Advertising