Reset switch port – Allied Telesis AT-S63 User Manual
Page 155
Advertising
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
155
RESET SWITCH PORT
Syntax
reset switch port=
port
Parameter
port
Specifies the port to reset. You can reset more than one
port at a time.
Description
This command resets a port. The reset takes less that a second to
complete. You might reset a port if it is experiencing a problem
establishing a link with its end node. The port retains its current operating
parameter settings. To reset a port to the factory default settings, use
“PURGE SWITCH PORT” on page 154.
Example
The following command resets ports 5 to 8:
reset switch port=5-8
Equivalent Command
set switch port=
port
softreset
For information, see “SET SWITCH PORT” on page 156.
Advertising