Allied Telesis AT-S63 - Manual (Page 719)

AT-S63 Management Software Command Line User’s Guide
Section VIII: Port Security 719
intrusionaction Specifies the action taken by the port in the event port
security is violated. This parameter applies only to the
Limited security mode. Intrusion actions are:
discard Discards invalid frames. This is the
default setting.
trap Discards invalid frames and sends a
management trap.
disable Discards invalid frames, sends a
management trap, and disables the port.
The intrusion action of a port operating in the Secured
or Locked security level is to discard invalid frames.
learn Specifies the maximum number of dynamic MAC
addresses a port on the switch can learn. This
parameter applies only to ports set to the Limited
security mode. The range is 1 to 255 addresses. The
default is 255.
participate Enables or disables the intrusion action on the port.
This option only applies to the Limited security mode
and only when a port’s intrusion action is set to trap or
disable. This option does not apply when intrusion
action is set to discard. The options are:
yes, on, true Enables the trap or disable intrusion
action. These options are equivalent.
no, off, false Disables the trap or disable intrusion
action. The port still discards invalid
ingress frames. This is the default.
These options are equivalent.
Description
This command sets and configures a port’s security mode. Only one mode
can be active on a port at a time.
To view a port’s current security mode, use the command “SHOW
SWITCH PORT SECURITYMODE” on page 724.
The management software displays a confirmation prompt whenever you
perform this command. Responding with Y for yes completes your
command, while N for no cancels the command.