Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 430
Chapter 23: Internet Group Management Protocol (IGMP) Snooping Commands
430
Section III: Snooping Protocols
Examples
The following command activates IGMP snooping, sets the IGMP topology
to Multi-Host, and sets the timeout value to 120 seconds:
set ip igmp snoopingstatus=enabled hoststatus=multihost
timeout=120
The following command changes the topology to Single-Host:
set ip igmp hoststatus=singlehost
The following command disables IGMP snooping:
set ip igmp snoopingstatus=disabled
Equivalent Commands
disable igmpsnooping
For information, refer to “DISABLE IGMPSNOOPING” on page 426.
enable igmpsnooping
For information, refer to “ENABLE IGMPSNOOPING” on page 427.
AlliedWare Plus
Command
Syntax
To set the maximum number of multicast addresses the switch can learn:
ip igmp limit
numbermulticastgroups
To set the time-out period for inactive host nodes:
ip igmp querier-timeout
timeout
Mode
Configure mode
Description
You cannot set these IGMP snooping parameters with the AlliedWare Plus
commands:
The IGMP host node topology
The maximum number of multicast addresses the switch can learn.
You also cannot identify the ports that the routers are connected to on the
switch.