Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 590
Chapter 31: Port-based VLAN, Tagged VLAN, and Multiple VLAN Mode Commands
590
Section VI: Virtual LANs
AlliedWare Plus
Command
Syntax
vlan
name
vid
vid
Mode
VLAN Configuration mode
Description
To create a new VLAN with the AlliedWare Plus commands, you perform
two steps. In the first step you create the VLAN by assigning it a name and
a VID with this command in the VLAN Configuration mode. Then you go to
the Port Interface mode and assign the tagged and untagged ports. The
commands for assigning the ports are described in the AlliedWare Plus
command in “ADD VLAN” on page 584.
Example
This example creates the Engineering VLAN and assigns it the VID 5:
awplus> enable
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan Engineering vid 5