Enable stp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 520
Advertising
Chapter 28: Spanning Tree Protocol (STP) Commands
520
Section V: Spanning Tree Protocols
ENABLE STP
Syntax
enable stp
Parameters
None.
Description
This command enables the Spanning Tree Protocol. To view the current
status of STP, refer to “SHOW STP” on page 530. The default setting for
STP is disabled.
Note
You cannot enable STP until after you have activated it with
“ACTIVATE STP” on page 518.
Example
The following command enables STP:
enable stp
AlliedWare Plus
Command
Syntax
spanning-tree stp enable
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree stp enable
Command
Available
AlliedWare Plus
Advertising