Allied Telesis AT-S63 - Manual (Page 618)

Chapter 33: Protected Ports VLAN Commands
618 Section VI: Virtual LANs
ADD VLAN GROUP
Syntax 1
add vlan= name | vid ports= ports frame=tagged|untagged
group=uplink|1..256
Syntax 2
add vlan= name | vid [taggedports= ports ] [untaggedports= ports ]
group=uplink|1..256
Parameters
vlan Specifies the name or VID of the protected ports
VLAN where ports are to be added. You can identify
the VLAN by either its name or VID.
ports Specifies the uplink port(s) or the ports of a group.
For instructions on how to enter port numbers, refer
to “Port Numbers in Commands” on page 47.. This
parameter must be used with the FRAME parameter.
frame Identifies the new ports as either tagged or untagged.
This parameter must be used with the PORTS
parameter.
taggedports Specifies the tagged ports to be added to the VLAN.
untaggedports Specifies the untagged ports to be added to the
VLAN.
group Specifies that the port(s) being added is an uplink
port or belongs to a new group. If the port(s) being
added is an uplink port, specify the UPLINK option.
Otherwise, specify the group number for the port. The
group range is 1 to 256. The number must be unique
for each group on the switch.
Description
These commands perform two functions. One is to specify the uplink port
of a protected ports VLAN. The other function is to add ports to groups
within a VLAN.
Note the following before using this command:
ˆ You must first create the protected ports VLAN by giving it a name and
a VID before you can add ports. Creating a VLAN is accomplished with
“CREATE VLAN PORTPROTECTED” on page 620.