Allied Telesis AT-S63 - Manual (Page 472)

Chapter 27: SNMPv3 Commands
472 Section IV: SNMPv3
CREATE SNMPV3 TARGETPARAMS
Syntax
create snmpv3 targetparams= targetparams username= username
[securitymodel=v1|v2c|v3] [messageprocessing=v1|v2c|v3]
[securitylevel=noauthentication|authentication|
privacy] [storagetype=volatile|nonvolatile]
Parameters
targetparams Specifies the name of the SNMPv3 Target
Parameters Table entry, up to 32 alphanumeric
characters.
username Specifies a user name configured in the SNMPv3
User Table.
securitymodel Specifies the security model of the above user
name. The options are:
v1 Associates the User Name, or Security
Name, with the SNMPv1 protocol.
v2c Associates the User Name, or Security
Name, with the SNMPv2c protocol.
v3 Associates the User Name, or Security
Name, with the SNMPv3 protocol.
messageprocessing Specifies the SNMP protocol that is used to
process, or send messages. Configure this
parameter only if you have selected the SNMPv1 or
SNMPv2c protocols as the security model. If you
have selected the SNMPv3 protocol as the security
model, message processing is automatically set to
the SNMPv3 protocol. The options are:
v1 Messages are processed with the SNMPv1
protocol.
v2c Messages are processed with the SNMPv2c
protocol.
v3 Messages are processed with the SNMPv3
protocol.