Disable portaccess|portauth, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 728
Advertising
Chapter 39: 802.1x Port-based Network Access Control Commands
728
Section VIII: Port Security
DISABLE PORTACCESS|PORTAUTH
Syntax
disable portaccess|portauth
Note
The PORTACCESS and PORTAUTH keywords are equivalent.
Parameters
None.
Description
This command disables 802.1x Port-based Network Access Control on
the switch. This is the default setting.
Example
The following command disables 802.1x Port-based Network Access
Control on the switch:
disable portaccess
AlliedWare Plus
Command
Syntax
no dot1x system-auth-ctrl
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# no dot1x system-auth-ctrl
Command
Available
AlliedWare Plus
Advertising