Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1001)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 985
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Range 0.1 ... 999999.0 s
Default value 2.0 s
Temperature
Temperature
Measuring temperature which can be entered manually. If a temperature
sensor is connected and the Temperature measurement is set on the
General/Hardware tab under Sensor to automatic or continuous, then
the temperature will be measured continuously.
Range -20.0 ... 150°C
Default value 25.0
Switch off stirrer during measurement
Switch off stirrer during measurement
on | off (Default value: off)
If this option is activated, then the stirrer is switched off during the meas-
urement. In this case the following two parameters can be edited:
Stir before measurement
Stirring time between end of dosing and measurement.
Range 0 ... 999999 s
Default value 0 s
Pause before measurement
Waiting time before the measurement during which no stirring takes place.
Range 0 ... 999999 s
Default value 0 s
5.6.4.16 STDADD auto
5.6.4.16.1 STDADD auto - Overview
Dialog window: Method ▶ STDADD auto ▶ Properties... ▶ STDADD auto - 'Command
name'
Command for Standard addition with automatic addition of the standard
addition solution from a dosing device in such a way that a constant poten-
tial difference results.
Devices
This command can be executed with the following devices: