Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 947)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 931
Identifica-
tion Description
.LP.CAx Calculated value × (1...3) for the last measuring point of
the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of the
measuring point list
.LP.MEA Measured value for the last measuring point of the meas-
uring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point of the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.SLO Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.STY Type of stop with which the command was stopped: 1 =
normal;0 = manual or after error
5.6.4.8.2 MEAS Conc - General/Hardware
Tab: Method ▶ MEAS Conc ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device, the sensor and the stirrer are defined
on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.