Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 441)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 425
Command variables
The following command variables are generated in the method run by the
command SERIE START and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended
5.6.2.5 SERIES END
Dialog window: Method ▶ SERIES END ▶ Properties.. ▶ SERIES END 'Command
name'
Start command for series end track.
Appearance
The command has the following appearance:
Parameters
Command name
Name of the command.
Input 25 characters
Live display
on | off (Default value: on)
If this option is enabled, then the track will be shown in the live display.
Command variables
The following command variables are generated in the method run by the
command SERIES END and can be used in formulas under the designation
'Command name.Variable designation':